111.00 – Galv Resilient Bars 3m / Sound Deadening Flexi RB1 Gyproc (wall And Ceilings)x30

Galv Resilient Bars 3m / Sound Deadening Flexi RB1 Gyproc (wall And Ceilings)x30 – You are buying 30 number Resilient bar soundproofing: Resilient Flexible Bar overview A vibration absorbing thin steel channel used on timber studs for walls & fixed beneath timber joists for ceilings. This allows the new wall or ceiling to be de-coupled from the main structure & will reduce both vibration & impact noise penetration. testimonial “If you’re soundproofing a ceiling you need this. Really cuts down impact noise from upstairs. Has really helped us cope with living under noisy neighbours.” James Clark description. Use on Ceilings Resilient Bars are essential to assist bring suspended timber floors into compliance with the Part E building regulations requirements for noise control through converted separating floors for flats. Used in connection with other sound insulating materials, the resilient bars will create an effective acoustic break between the bottom of existing joists & ceilings. If not fitted directly beneath the floor joists, Noise Reducing Resilient Bars can be supported by 50mm square battens screwed to the underside of any existing ceiling. (See installation instructions from link above right hand side). The fitting of the Bars alone along with a double layer of 12.5mm acoustic plasterboard will achieve around an 11dB improvement. Combined with a sound deadening quilt between the joists & a double layer of 12.5mm Soundbloc plasterboard we could expect this to be around a 16dB improvement. This should make a considerable difference to reducing the noise nuisance that may be experienced. Acoustic plasterboard is then screwed to the corrugated section of the bar using self-drilling screws & for best results; 2 layers totalling a minimum of 25mm thickness should be installed. A greater sound insulation can be gained if a minimum 50mm acoustic insulation is installed between the battens before fixing the acoustic plasterboard. When installed beneath an existing ceiling you can expect significant improvements in both airborne noise & impact sound. Use on Walls Resilient Bars are moreover recommended to upgrade party walls; particularly effective at reducing loud music or bass sound passing though any wall. Ideally you would build a new stud batten frame spaced approximately 25mm away from the existing wall. This will create a sealed air gap between the new wall & the existing one. Fill in between the studs with Acoustic Mineral Wool & it does not matter if the wool comes into contact with the existing wall. This is loose fitted & should not be installed too tightly. Screw the Resilient Bars onto the frame horizontally using self drilling screws followed by 2 layers of 12.5 mm Soundbloc plasterboard. You need to make sure that both layers of plasterboard do not touch the surrounding walls, floor or ceiling. Fill in the little gap with flexible non-hardening acoustic sealant & then your whole system will be independent & floating on the bars. Technical Information Length: 3m Overall thickness: 15mm Steel gauge: 0.5mm Weight: 0.37kg/m Delivered to your door in the UK for only £5.00 subject to restrictions below England — All areas ok apart from Islands Scotland — All areas ok apart from Highlands & Islands which may be slightly higher or remote areas — please check first Wales — All areas ok N Ireland — Please check all areas 01524 752952 or info@building-supplies-direct.com All goods supplied are first grade, new & are fully approved by the local authorities. Depending on your location another brand may be supplied yet is the same specification If you have any other requirements please ask, we will happily put a listing on ebay for your requirements. We moreover supply the acoustic plasterboards & the fixings if requiredQuestion? Ring Dave 07533 675183 (please leave number if i,m busy i will call you back) Email : info@building-supplies-direct.comOffice 01524 752952 Payment Paypal, Cheque, BACS, Credit / Debit card direct to the office Returns Returns will be accepted subject to a return charge being applied. Terms & Conditions Full terms can be supplied upon request Delivery Please note we will endeavour to deliver on schedule at all times yet on occasions that a delivery is delayed we will not be held responsible for labour charges, fees involved or late delivery penalties. Feedback We always leave positive feedback for our customers. If there is a problem with your delivery or something is damaged please contact us so we can resolve the problem before feedback is left. If a delivery is expected on a certain day please let us know by 4pm if it has not arrived & we can chase it up for you.

Galv Resilient Bars 3m / Sound Deadening Flexi RB1 Gyproc (wall And Ceilings)x30 price is correct at time of posting.